EMI Measuring System
This devices is Automatic measuring system can be operate by Software such as Spectrum analyzer and EMI receiver.
Custumizing either automatic or manual operation can be provide besed on your request.
Inquiry| Product name | Type |
|---|---|
| EMI Test receiver | ESW8 (2Hz～8GHz) ESW26 (2Hz～26.5GHz) ESW44 (2Hz～44GHz) 
ESR3 (9kHz～3.6GHz) ESR7 (9kHz～7GHz) ESR26 (9kHz～26.5GHz) |
| Oscilloscope |
RTO(600MHz/1GHz/2GHz),RTM(500MHz) 
|
| Network Analyzer |
ZNB(9kHz~4.5/8.5GHz),ZVL(9ｋHz～3/6/13.6GHz) 
|
| Antenna |
Biconical,Log periodic,Horn  
|
| LISN | ENV216 
ENV432 NNBM8124 |
| RF current probe |
F-65
|
| BCI probe Attenuator Calibration fixer |
F-140, 50FH-030-300, FCC-BCIC-2, etc.
|
| RF signal selector |
RFS02 type, RFS03 type RF Signal selector can change input of Attenuator, RF pre amp or input of Bypass by operating switch of RF Signal selector without changing a connector in EMI Measuring. Performing Automatic measuring by equipping GP-IB for remote operating |
| CCTV System for monitoring EUT |
COC-1000(Controller), TV2200(Stand) CCTV, CCTV controller, Camera stand/mast. During EMS testing, you can check the EUT behaviour from a Shielded room on a monitor. CCTV controller can operate camera angle from Measuring room. |
| TFT liquid crystal monitor |
TFT liquid crystal monitor monitor for Measuring control room Monitor size by requested (15″ 17″ etc.) |
| External monitor for receiver |
ECM01 Shielded monitor using at Anechoic chamber Monitor size by requested (15″ 17″ etc.) |
| Comb generator for calibration |
CG-515,CGO-5100A  
|
| Coaxial cables |
|
| LISN controller |
LC4000 This device is to switch phase of LISN in Conducted Emission Measuring of EMI Measuring System |
| Absorbing Clamp |
PS5000Ⅲ The absorbing clamps are used for measuring Radio noise power in lieu of Radiated emissions measurements. |
| Controller for Absorbing Clamp |
DOC-200 series This Controller is to remote operate Clamp used in Conducted Emission Measurement/Interference Power |
